Problem adjusting Display Area

[gothicawakening]

After updating the firmware (OTA) today I've run into a new problem.

The image goes past the edge of the TV I am testing on, and the Adjust Display Area setting is not working correctly.

See video of the issue here: www.youtube.com/watch?v=CQOERR80TzU

It allows me to adjust 1 of the 4 parameters (eg. Top) but then never updates the number listed on the slider. When I adjust any other parameter (say Left), the others get reset to 0.

You can see this happening in the video

    1) I set top to about 4
    2) When I then try and set Left, Top jump back to 0

Obviously this is a big problem as every app is now going past the edge of the screen.

I think this might be a bug, could someone else check if they experience the same issue?

[Chess]

I have the exact same problem.

Anyone who have a solution to this?

[gothicawakening]

No solution yet - quite frustrating. Waiting on updated firmware I guess..

[Futarque]

Tried to reproduce issue here, but have not been able to yet.

I see you are running 720p resolution.
I have 2 TV sets here that applies overscan on 720p60, but not at 1080p60.
Best suggestion is to remove overscan on the TV, as we only introduced the adjustment as a last resort.
It's not good to do adjust both on TV and Box.
So if possible then remove overscan on TV.
Does your TV support 1080p, then try this also.

We will double check adjustment on the next release.

[gothicawakening]

Thanks for checking. That TV is at work so I'll bring the box in again tomorrow and see what I can do with your suggestions.

It's this TV: www.220-electronics.com/tv/samsung-la37r81-multisystemlcd.htm which has a native resolution of 1366x768 which may be part of the problem.

I've not had the same issue with my Panasonic Projector and the Rhoboard, so it's likely only happening at odd resolutions (not 1080p).

@ Chess - Any chance you could let us know the Model of your TV?

[Fin]

Got The same problem. And it seems like nothing is happening in Here to fix The issue

[Fin]

Additional note I am running on bulldozer 1.0.139

[finestra]

I have the same problem and I am running on build 1.0.139